Diluted pesticide spraying pesticides operation is often required to. When the concentration of pesticides is high, there will be phytotoxicity. At this time, the pesticides need to be diluted to reduce the concentration, but at the same time, the concentration cannot be too low, which will lose the efficacy. Considering that it is safe and effective, either when the drug is used, the concentration of the drug solution is limited, or the amount of the drug per unit area is limited. To this end, there are several provisions in the instructions for use.
For the preparation of the drug, the dilution factor is as follows: for the prevention and treatment of tomato green blight, use 14% solution of lycopene copper water solution or 50% copper succinate (DT) wettable powder 500 times solution. Use 1 liter of 14% lycopene copper water plus 300 kg of water or 1 kg of 50% copper succinate wettable powder plus 500 kg of water. Since 1 kg of water can be equivalent to 1 liter of capacity, the lysine copper is formulated in a volume ratio, and copper succinate is prepared in a weight ratio. Although they all have a little bit of error, they are completely negligible in field operations. A similar description is to specify the amount of medication per unit area and the amount of water exchanged. For example, the control of white-backed planthoppers is carried out with 25% of chlorpyrifos WP 30-40 grams per acre, and 50-75 kilograms of water is applied to prevent and control. This is the clearest and most common explanation.
For the prescription of the medicine, the application amount per unit area is as follows: for the control of rice leaf roller, 48% chlorpyrifos EC 900-1500 ml per hectare, sprayed with water. There is no emphasis on the amount of water exchanged. Because the amount of liquid per hectare is different when using different application machines, the amount of water can be changed, but it is necessary to ensure the use of pure medicine or medicine per unit area. Most of the rules for using herbicides are the same.
In the above two cases, no calculation is required, as long as the weighing is ensured, it is safe and effective.
The concentration of the active ingredient in the prescribed liquid is usually specified in the instructions for use of the plant growth regulator. Due to the low concentration of the liquid, it is often expressed in parts per million or in "ppm". Now use more milligrams of active ingredient per liter of liquid, ie milligrams per liter. For the purpose of controlling cotton growth, the spraying concentration is 60-80 mg/L, which is 60-80 ppm of ketamine. If 25% water is used, the dosage is 60-80 mg/L divided by 25%. It should be diluted with 240-320 ml of the drug with 1 liter of water.
Product advantages:
1. 100% fresh aluminum alloy 6063-T5, iron containing is less than 2% , sturdy and durable, full thickness 3.0mm.
2. 3 layer PVDF color coating, thickness more than 80 microns, excellent weather resistance, never fade,More upscale appearance.
3. 100% fresh virgin Bayer Polycarbonate Sheet, 30-50 micron anti-UV coating, can withstand 75% ultraviolet light, impact strength is 300 times that of ordinary glass, 10 years warranty.
4. The motor adopts the domestic leading brand and is guaranteed for 10 years.
5. Rugged and novel internal design, 3.0mm thick aluminum alloy profile, 4-10mm high strength impact resistant endurance board, can withstand snow loads of 30 to 45 cm.
6. High anti-aluminum structure provides maximum safety even in strong winds (strongest 12 winds) (34m / s strong wind).
Novel structure and easy installation
7. Packaging, protecting the product during shipping and making it easier to install.
Aluminium Canopy,Car Canopy,Garage Canopy,Polycarbonate Canopy
FOSHAN KASO BUILDING MATERIAL CO.,LTD , https://www.kasocover.com