Bathroom design needs to pay attention to where

With the improvement of people's living standards, today's bathroom is not only a "convenience", but more emphasis on leisure and relaxation of life attitude. Bathrooms often have water, so pay attention to "three defenses", that is, the ground waterproof, anti-skid, moisture-proof roof.


Cano tile    Carrie bathroom

In general, the bathroom has been waterproofed when the new house is delivered, but consumers tend to redecorate the bathroom, such as paving the floor, leveling the floor, replacing the sanitary ware, etc. This may damage the waterproof, so it is recommended that no matter the decoration, Whether to damage the waterproof layer should be re-do a waterproof, and waterproof must be thorough, such as the seam between the wall and the ground and the pipe between the ground and water at the ground seam, is the most vulnerable to leakage, must deal with These are good corners. Wall waterproofing can not be sloppy, because the bathroom is also responsible for the function of the shower room, when a lot of water splashed on the wall, if there is no waterproof layer on the wall, it will cause the side of the wall seepage, so the waterproof layer should brush up from the ground 10 to 20 cm polyurethane waterproof coating, then the ground to redo polyurethane waterproof to enhance the waterproof.

For ease of maintenance, many bathroom pipes are arranged in the ceiling, so the moisture protection of the roof is very important. To make the bathroom roof waterproof, it is best to apply a layer of water glass on the roof, and then use a waterproof PVC buckle plate.

The toilet often has water, and it is easy to slip on the floor. To ensure the safety of the toilet, a special bathroom floor tile or sauna floor should be selected. These products are highly water-resistant and will not be too slippery in the case of water. A lot of safety.

1. Try not to damage the original waterproof layer, as new houses are generally made waterproof when delivered.

2. Resurface the tiles to make the floor waterproof. Repeat the brushing 2 to 3 times with polyurethane waterproof coating.

3. The seams between the wall and the ground and the pipeline between the upper and lower water at the seams, waterproof coating must be applied in place.

4. The decoration company is required to do a good job of cement mulch to the toilet.

5. In the general waterproofing treatment, the wall surface adjacent to the shower position is not to be treated with a waterproof height of 30 cm.

6. When the pipeline, floor drain, etc. cross the floor during construction, the waterproof layer around the hole must be carefully constructed.

7. After the waterproof project is completed, close the door and the water outlet, and use the 24-hour "water storage test" to check and waterproof.

Bathroom Notice Construction Acceptance Paint New House Glass Cement Decoration Find Decoration Company Okay Tile Floor Glass Tile Glass Door Bathroom Waterproof Toilet Tiles Bathroom Tiles Bathroom Door Floor Tile ld Tile

PLS UVC Lamp

Ultraviolet Lamp,Pls Uvc Light,Pls Uvc Bulb,Pls Uvc Tube

Changxing leboom lighting product CO.Ltd. , https://www.leboomuvd.com