Stainless steel pump is a newly developed multi-functional horizontal rotary pump products, mainly pump, gear, bearing, safety Valve, bearings and seals and other mechanical components. Can transport a wide range of media from tap water to industrial liquids. The stainless steel pump's overcurrent components are stamped with stainless steel for different temperature, flow and pressure ranges. The stainless steel pump is suitable for non-corrosive or lightly corrosive liquids, Liquid maximum temperature up to 120 ℃. A complete gear pump includes a motor, reducer, coupling and pump head several parts, the pump head part of the pump housing, front and rear side cover, gear shaft, sliding bearings and shaft seal composition. High-temperature gear pump is a positive displacement pump, work rely on the main, driven gear changes caused by the work volume changes to transport the melt. Working volume by the pump body, gear tooth groove and the function of the side plate with the composition. When the gear rotates in the direction as shown in FIG. 1, the melt enters the tooth grooves of the two gears of the suction chamber. As the gear rotates, the melt is brought into the discharge chamber from both sides, and the gears mesh again to make the The melt is forced out of the discharge chamber and pressure fed to the outlet pipe. As soon as the pump shaft is turned, the gear presses the melt down to the outlet side so that the pump outlet can reach very high pressure with little or no effect on flow and discharge pressure. A check valve is installed on the output pipe of the gear pump so that the liquid in the system will not flow backwards when the pump is being serviced and the output pipe is in place. When the gear pump is under a load stop, a partial vacuum is generated in the output pipe to prevent the pump reverse. High viscosity gear pump outlet pipe also set safety valve and other protective devices, so once the pump outlet channel blockage, you can open the safety valve pressure relief. The safety valve can be cast in one piece with the pump body or pump head and can also be assembled separately. Gear made of high-quality carbon steel, but also according to the special needs of users with copper or stainless steel material made of the bearing seat on the packing box, the axial sealing effect. KCB-300 ~ 960-type pump with mechanical density device, the bearings using single row radial ball bearings. KCB-18.3 ~ 83.3-type pump with three oil-resistant rubber ring and the middle of a spacer ring composed of adjusting pressure on the cover of the two nuts to adjust the degree of sealing, bearings using copper-based powder oil bearing. In addition, stainless steel gear pumps can be filled with packing to good flexibility, high temperature and low temperature, chemical stability and self-lubricating flexible graphite as a filler. Stainless steel gear pump equipped with safety valve, when the pump or discharge pipe failure or mistakenly discharge valve is completely closed and produce high pressure and high pressure impact valve will automatically open, remove some or all of the high pressure liquid back to the low pressure chamber, Thus the pumps and pipes play a safe role with a flexible coupling directly connected with the drive motor, and mounted on a common cast iron chassis.
Auto Tools,A/C Detection Tool,Adapter Detection Tool,Plug Adapter Detection Tool
LONG TERM ELEC. CO., LTD , https://www.longterm-hvac.com