Marble is widely used in home decoration, because marble can be adjusted manually, so a variety of colors, flexibility is good, convergence is not obvious, the overall feeling is very strong, and colorful, with a ceramic luster, high surface hardness, easy to damage , corrosion resistance, high temperature, and very easy to clean. Next Xiaobian introduces marble maintenance skills.
Marble care notes
1. The marble surface should be dry and smooth. After the renovation, the nanometer wool pad should be used as far as possible to dry the surface. The temperature should be about 50 degrees before the crystal surface treatment.
2. Use clean steel wire and pad.
3. The stone should be shut down immediately when it emits bright glass.
4, the use of neutral crystal surface agent, neutral renovation pulp.
Marble maintenance tips
1-2 times a week, the stone refurbished machine equipped with nano-wool pad (Brush pad) (if there is a 300-400 high-speed machine is better) spray a small amount of crystal surface maintenance agent or crystal hard powder on the clean or washed floor (The crystal hard powder must be added with water. The amount of water can be determined according to the humidity. The amount of water should be more when the weather is dry.) 1-2 grams per square meter.
Smooth it with a stone refurbished machine, then grind it to light. Finally, use the dust to push the dust off the floor. Should be sprayed in sections, each 1-2 square meters. The pad should be kept clean. When too much dust is on it, the effect will be affected. If it is found to be stained, use it on the other side and change it until it is contaminated on both sides. Depending on the area of ​​work, provide enough cleansing pads to clean the stains and dry them before use. On a smooth dark floor, the pad can be replaced with a wire pad, which is better, but it should be noted that the floor is not smooth, or contamination of the pad will make the floor black.
Local maintenance: Laying a waterproof mat in the middle of the door and the road where many people are walking to prevent sand grains from scratching the crystal surface. 1-2 times a month local maintenance, first put the crystal surface maintenance agent into the watering can, shake and spare. Match the stone refurbished machine with the red scouring pad or steel wire pad, spray the crystal surface maintenance agent dispersedly on the clean or washed stone surface, spread the ground (about 1-2 square meters) with the stone care machine, and then Slowly and evenly dry, you can see bright. Do it paragraph by paragraph.
Note that the crystal surface maintenance agent should be evenly sprayed and evenly grounded on the ground. If uneven spots are left behind and dark shadows are found, a small amount of regrinding can be added. The pad is very dry at the beginning and should be added with some crystal maintenance agent, which can be slightly reduced later. If the work area is large, two stone retreaders shall be used as a group, one shall be responsible for distribution and one shall be responsible for polishing, and the efficiency and effectiveness shall be significantly improved. Finally push the powder on the floor with dust to push it clean.
Editor's summary: About marble maintenance techniques are introduced here, and I hope to help everyone. If you want to know more related information, you can pay attention to this website information.
Marble marble tile
Silicon Calcium Barium Alloy,High Quality Silicon Calcium Barium Alloy,Silicon Calcium Barium Alloy Details, Anyang Penghang Metallurgical Refractory Co., Ltd.
Ningxia Xinshuncheng Special Alloy Co., Ltd. , https://www.xinshunchengalloy.com