Those who understand the decoration know that tiles are often left when they are laid. This practice is caused by the shrinkage of the tiles. If this gap is not properly handled, it will not only affect the interior appearance, but also the tiles will be easily damaged. Tile grouts are used to fill gaps between tiles. What is the use of tile grout? How do we use a tile grout?
First, what is the use of tile grout
Tile grout is mainly made of cement + quartz sand + pigment, and then mixed with some additives. Tile grout has a wide range of uses and is suitable for almost all stone materials such as floor tiles, marble, mosaics, granites, antique tiles, cultural stones, etc., as well as very good decorative effects.
The tile grout is used on the gap of the tile, and it will form a smooth surface such as porcelain after solidification. It is not only very clean, but also has the same effect as the ceramic tile. It has very good wear resistance, oil resistance, water resistance, and dirt resistance. Self-cleaning properties.
It can make the gap between tiles no longer filth, solve the problems of dirty, black, moldy, difficult to clean and so on, so as to avoid the danger of mold damage to the human body. And not only new and ordinary tiles can be used, even with a few years of tiling can be used.
Tile grout not only has strong adhesion but also has a certain toughness. It can absorb the constant vibration and contraction force of the base surface and the brick, thus preventing the crack of the tile. It can also prevent moisture from infiltrating into the interior of the tile to avoid the phenomenon of anti-slurry and hanging tears. It is also colorful, non-toxic, non-polluting and environmentally friendly. It is the best caulking product for tile gaps.
Second, how to use tile grout
1. Before using the tile grout , it is better to clean the tile seam first. It is better not to clean it with water. Make sure that there is no debris between the bricks and there is no water accumulation.
2, when the construction must first deploy a good product, if the dry powder filling joints, there is no effect. When blending the product, according to the appropriate proportion, that is, the ratio of powder:water is 4:1, the grout is mixed evenly, and the mixture can be stirred until there is no creamy paste, and after 10 minutes, it can be mixed for one time. .
3, when the sewing, will be along the diagonal direction of the tile squeezed into the gap, do not have to stay empty, you can use the action with the gap beveled to scrape more slurry, to avoid the gap within the slurry The material can be carried out with the use of a squeegee knife, which can prevent scratching of the tile by the squeegee product.
4, after the initial curing of the seaming agent, you can use the wet sponge to clean the seams on both sides of the tile joints. At this time, you need to press the seams to press the tile gap, which can make the seaming agent more dense. Smooth effect. If the tile water is too high, the grout has penetrated into the tile and can be cleaned with a tile cleaner.
5. Within 12 hours after the construction of the caulking agent, it is necessary to spray water on a regular basis so as to keep the groove joint agent moist. This will allow the caulking agent to better adhere to the ceramic tile, and it is not easy to crack off. Finally, a thin layer of wood lacquer oil is applied to the surface to facilitate cleaning in the future.
Editor's Note: The above is about the use of tile grout and how to use a good introduction of tile grout, I hope the small editor today shared the content, we can understand more about tile grout, better use it. If you want to know other relevant knowledge, you can pay attention to our website information.
Tile seaming agent
PP Pressing Faucet,Pressing Type Faucet,Pp Pressing Type Faucet,Pressing Type Plastic Faucet
Cixi Ruisheng Electric Appliance Factory , https://www.rswatertap.com