Waterproof bathroom "four in place"

Because of its special function, the position of the bathroom in the decoration is very important, especially the waterproof project. If there is a quality problem, it will bring inconvenience to the home, and it will leak to the downstairs, causing neighborhood disputes and economic losses.

At present, there are many kinds of materials used for waterproofing the bathroom. Basically, the waterproof effect is good. The specific construction details should pay attention to the "four o'clock in place".

1. Leveling the floor: Before installing the floor tiles, first level the floor with cement mortar and then do waterproofing treatment to avoid leakage of the waterproof coating due to uneven thickness.

2. Seam painting: The joint between the bathroom wall and the joint between the upper and lower water pipes and the ground is the most prone to problems. All waterproof coatings must be applied “in place”.

3. Wall treatment: Waterproof coating of about 30 cm height should be made on the wall surface. If it is a non-load-bearing light-weight wall, the entire wall surface should be covered with waterproof coating. If it is a two-piece shower screen, the two walls that are connected should also be fully coated. If you use a bathtub, the wall adjacent to the bathtub should also be coated with a waterproof coating along the bathtub.

4. Waterproof test: After the construction is completed, all the water in the toilet will be blocked, and a 25 cm high "can" will be built at the door, and then 20 cm of water will be poured into the bathroom. After 24 hours, you will check the surrounding walls and the ground for leaks. This kind of experiment is the key to ensure the quality of the waterproof project. It must be done.

Rare Earth Silicon Magnesium Calcium Alloy

Rare Earth Silicon Magnesium Calcium Alloy,Silicon Magnesium Calcium Alloy,Rare Earth Alloy Product,Inoculant Lump Product

NINGXIA HELANSHAN METALLURGY CO., LTD. , http://www.nxhlsyjferrosilicon.com